Some Simple Plumbing Tips

If water is coming out too hot or too cold, correct plumbing tips assist individuals in solving these problems. By following good advice they can save money on otherwise expensive plumbing repairs done by professionals. Fixable problems include clogged drains, frozen pipes, and other plumbing problems.

When there is no hot water it is important to check for an unlit pilot light or one that does not continually burn. If it is unlit, carefully relight it. If it burns out make sure the gas controls are on all of the way. Also check that the thermocouple is connected securely to the gas control unit and is nearby the pilot flame.

If there is hot water but not enough of it, check the thermostat settings. Try turning it up higher and see if the problem is solved. Also check if pipes are openly exposed and if so try installing insulation. Sometimes sediment has settled within the tank and can reduce hot water availability. In this case, turn off the gas and then drain it out. Inspect for any leaking faucets that will need to be repaired or replaced.

If water is too hot it is also necessary to check the thermostat. Try to lower its setting and see if the problem is resolved. An additional possibility is that the exhaust vent is blocked. If this is the case, remove the blockage.

Faucets that are turned on in cold weather without water coming out may be attached to frozen pipes. This can be prevented or quickly treated before further damage takes place. To prevent the initial freezing process always make sure a stead trickle is escaping from each faucet. Any exposed pipes should by heated with a heat lamp or small heater. Uninsulated pipes can also be wrapped in insulating materials like tape or foam.

If pipes are already frozen, shut the water off at the main valve. Then open the faucet that is closet to the frozen pipe. This allows the water to drain as the ice melts. In case of leaks, make the surrounding areas waterproof with coverings or containers. Slowly warm up frozen pipes from the faucet down to the direction of more frozen regions. This is done with heat lamps, heating pads, hair dryers, or propane torches.

Unclogging a drain can be done after examining stoppers in a sink or tub. Look to make sure it is open all of the way and not clogged with tangled hair or debris. If these are not problems the drainpipe is likely clogged. This can be fixed usually using a plunger or any chemical drain cleaner solution.

Not enough, too hot, or no hot water can be remedied with careful inspection and minor corrections. Malfunctioning thermostats, exhaust vents, pilot lights, or faucets can all also be easily corrected. Frozen pipes are preventable or quickly fixable with heating equipment such as hair dryers. A clogged drain can be emptied of any plugging debris or hair and cleaned using chemical mixtures available at most stores. These plumbing tips save valuable money.

Our Plumber is a leading plumber San nAntonio and the South Texas Area. Offering plumbing repair and plumbing services for all of your plumbing needs. For Water Softener Service please follow this website